How to Measure Sliding Bypass Closet Doors

For sliding/bypass closet doors only. This guide collects measurements for a quote. It does not specify the final panel sizes or installation clearances. Measuring a hinged interior door instead?

1. Identify the finished closet opening

Measure the finished opening between the left and right finished surfaces—not the rough framing. If trim, casing, baseboard, or an existing track changes the usable space, photograph and note it.

2. Measure width in three places

  1. Width across the top of the finished opening, where the upper track will be installed.
  2. Width across the middle.
  3. Width across the bottom, where the lower track or guide will sit.
Illustration showing finished closet opening width measured at the top, middle and bottom; mark the widest measurement.
Record all three widths and circle the widest width for review.

Record all three measurements to the nearest 1/16 inch if possible and mark the widest width. Do not round to a standard door size or automatically subtract track clearance.

3. Measure finished height in three places

  1. From the finished floor to the underside of the finished opening at the left.
  2. Repeat at the center.
  3. Repeat at the right.
Illustration showing finished closet opening height measured at left, center and right; mark the smallest measurement.
Record all three heights and circle the smallest height for review.

Measure from the surface on which the track/guide will actually sit and mark the smallest height. Note carpet, tile, hardwood, or unfinished flooring and any planned flooring changes.

4. Check track space and obstructions

  • Photograph the header and floor, including the existing upper channel and bottom track/guide if present.
  • Measure available front-to-back depth at the top and bottom; note shelves, organizers, switches, uneven walls, baseboards, and door stops.
  • Tell us whether the existing track is being reused or replaced. Track and channel sizes and offsets vary by model.
  • Note how many panels you want (for example, two or three) and how you want the doors to overlap.

5. Send the opening measurements for a quote

Use the worksheet below for each opening. Do not calculate panel width by dividing the opening width in half; panel overlap and track configuration are model-specific.

Opening / room: _________________________

Widths (inches): Top ______   Middle ______   Bottom ______

Heights (inches): Left ______   Center ______   Right ______

Floor / track condition: _________________________

Existing track reused? Yes / No / Unsure

Preferred number of panels: ______

Preferred CW Doors model / finish: _________________________

Other obstructions / notes: _________________________

Manufacturer guidance

Contractors Wardrobe provides model-specific installation instructions and track/channel information. The widest width and smallest height are reference measurements for review, not automatic manufacturing dimensions. We verify all manufacturer-required clearances, panel overlap, track requirements and the correct sizing before ordering.

CW Doors official wardrobe door installation instructions   |   CW Doors order and quote forms

Return to all CW Doors models or request help from SoCal Millworks.